Unlocking Raw Power: Why Pros Choose Booster PAC’s Hot Jaws
An auto tech needs access to raw power when rescuing a stranded vehicle with a dead battery. He needs that same raw power in the service bay as well. But power is only half the equation. The other half, and what often proves to be the bigger challenge, is delivering power to the disabled vehicle’s starter motor through cables and battery terminals. When technicians are dealing with rust, corrosion, and grease, the job becomes much more difficult.
The pros break through the challenges of overcoming dead batteries in real-world scenarios by relying on the Booster PAC line of jump starters from Clore Automotive. The Booster PAC line is known throughout the auto repair industry for its high-output ES Series batteries. But there is one specific feature specifically engineered to make Booster PAC the undisputed workhorse among professionals: industrial-grade ‘Hot Jaw’ clamps.
The Science Behind Hot Jaw Engineering
To understand Hot Jaw engineering and why it matters, we have to go back to standard jump starter clamps. They may look heavy-duty on the surface, but underneath the plastic housing are clamps that offer poor conductivity and weak spring tension.
This matters because poorly engineered clamps are likely to make contact on only one side of the jaw. This forces high amperage through a single, tiny contact point. Booster PAC engineers overcome this challenge with purpose-built Hot Jaw clamps featuring:
-
Dual Power Paths – Both clamp jaws are energized by way of heavy-gauge copper wiring. This creates two active pathways for power, doubling the potential contact area between jaws and terminals.
-
Corrosion-Penetrating Teeth – Booster PAC clamp jaws are built with high-tension, heavy-duty springs that drive deeply grooved metal teeth. The teeth bite through surface oxidation, battery acid residue, grease, and paint. The result is a clean, low-resistance connection.
-
Tough Construction – Booster PAC units are built with industrial-grade copper alloy construction that makes them extremely tough. The clamps can handle hundreds of continuous cranking amps without overheating or melting. The conductive copper components inside the jaws do not pit or thermally degrade.
If you have ever tried to jump-start a car using off-the-shelf jumper cables connected to dirty, corroded battery terminals, you know just how important a good connection is. Hot Jaw clamps guarantee a good connection every single time.
The Pros Depend on Hot Jaw Technology
Booster PAC is a favorite among pros because they have learned they can trust the brand’s technology. To the pros, time is money. They are not interested in cleaning filthy battery posts with a wire brush every time a vehicle needs a jump. They want to connect, crank, and go as quickly as possible.
Booster PAC’s Hot Jaw clamps cut through corrosion and grime when a tech is servicing a neglected fleet vehicle battery. They grab on and hold firmly when a tow truck driver is attempting to jump-start a car stranded on a busy highway in the middle of winter. Technicians of all kinds can perform back-to-back jumps on severely corroded batteries with no loss of starting efficiency.
A Brand for DIY Motorheads Too
It’s clear that Booster PAC has a prominent place in fleet garages and auto repair shops. Among all the brand’s features, its Hot Jaw clamps make Booster PAC units far superior to anything a pro could buy off-the-shelf. That also means that Booster PAC is a great choice for DIY motorheads as well.
Connections matter when you’re trying to jump-start a vehicle with a dead battery. So if you are tired of taking your chances with off-the-shelf units, consider investing in a Booster PAC jump starter.
